Fidget Spinners for Adults and Kids, Stress Anxiety ADHD Relief Figets Toy, Metal Finger Hand Spinner Toys with Luminous Light, Fidget Spinner Need Absorb Light Then Release in Dark

Best spinner yet
Longest spin so far is 8 minutes and 34 seconds. Better times with warmer temps. Includes an extra ball bearing.

It broke. But it was fun to watch.
It broke. It felt hefty, but was clearly not balanced well. The main body is cast and I didn’t see evidence of machining. The center bearing is held in using a brass threaded ring into the aluminum threaded bore. Both are soft metals, so don’t put too much stress on the threads. That retaining ring is really the only thing holding the bearing secure. The center posts are male – female threads which fit into the ID of the bearing. So, at a very small 1/8” (roughly) ID and 1/2” (approximately) OD, there is a ton of room for wiggle if anything gets loose through normal use, drops, etc. The bearing itself is a standard steel ball style, not enclosed, non lubricated. For the cost, I wasn’t expecting precision parts and all… so meh. I give it a 4 star overall because it was very, very entertaining to spool it up on the bench with the air nozzle and watch it rattle itself to pieces. It asked me to rate “sheerness, durability, and warmth.” It isn’t sheer, but if you grab it while it’s spooled up, you may have your fingers shorn off (3/5). Kids and people who don’t push the limits too hard may find it to be decently durable. But, I found it to be disappointing (3/5) after the maniacal laughing when it busted up at 20k+ rpm. It’s probably not rated for those rotational speeds. And by probably, I mean certainly most likely. Warmth? Not at all. It’s cast aluminum. Very cold. (1/5). Oh, and just in case you need to know, the lights are activated by placing the body in direct light for a reasonable amount of time. The closer to true UV you get, the brighter they become. The listing mentioned it a few times already but I want to make sure we all understand how ‘glow in the dark’ works… you know, in case a recipient of one of these has been in a coma since the 1950s – 1960s.

Honest Review
I purchased several spinners in an effort see which I may like but was unsure of which one would be best for me. Of the four purchased, two were the brand Innoplus. This particular Innoplus Spinner overall is above average n my opinion.The spinner had good weight to it. The writing is pressed into the metal with the exception of the logo being printed on the center where your finger and thumb will be, could be questionable on longevity for the logo. The iridescent green lines were quite appealing to the eye and were very bright when following the instructions provided on time of light exposer with the provided UV light on the product page.I regard to experience; it was a nice weight in the hand and could get a good spin using only one hand and spinning with a finger in the same hand. I did not have to consciously keep fingers very rigid while holding the spinner in an effort to keep them from interfering with the spin.In regard to spin time. I did a controlled spin by placing the spinner on a solid perfectly level counter top with no pressure applied from fingers or any outside influence to interfere with the spinner in any way. After holding the spinner down with one finger and spinning with the other hand to give it the greatest velocity potential. This spinner did the best of the the other spinners. A high time of 7:50 and a low of 7:28 (yes this is written correctly and not an error)The spinner overall is comfortable in size but 3rd largest in comparison to the ones bought. The spinner is absolutely not silent until it gets slower in spinning. At peak speed it is the loudest of the four and when in the hand it is still loud. Overall it is quite enough to not disturb anyone enough but I’d be cautious of trying to get high speed out of this in a quiet room as it will be heard.Good overall experience and contender among the four I purchased and in a side by side comparison it came in 2nd of 4 overall.